- Clean and brush tail hair thoroughly.
- Tightly rubber band a small lock from the underside of the tail to make a lock of hair about the width of your pointer finger.
- Carefully cut the hair straight across above the rubber band. Cut a minimum of 4 inches for your necklace or earrings.
- Take this log of hair and place it into a ziplog bag and then ship it to the following address:
Ride On Designs
7107 Suncrest Drive
Lynchburg, VA 24502
Note: Don't forget that we need a minimum of 4 inches for a necklace or earrings. If you are ordering a set that has both, we need 8 inches. Make sure to measure you hair before you send it.